Northwestern and Western Digital demonstrate a new way to write antiferromagnetic MRAM bits
Researchers from Northwestern University, led by Prof. Pedram Khalili, together with collaborators from Western Digital, demonstrated a new way to write data into all-antiferromagnetic tunnel junctions (ATJs) at room temperature. The researchers call the new mechanism octupole-driven spin-transfer torque (OTT). It was long assumed that antiferromagnets, with their zero net magnetization, cannot generate this kind of spin-transfer torque.

An antiferromagnetic tunnel junction pillar, beside the two spin configurations of PtMn3 that store a bit (image: Northwestern University)
Each junction sandwiches a thin MgO barrier between two layers of the non-collinear antiferromagnet PtMn3 (Mn3Pt). The same simple two-terminal structure is used for both writing and reading: a current pulse switches the antiferromagnetic state, and a resistance measurement reads it out. The researchers explain that the torque originates from an imbalance between intra- and inter-sublattice spin currents, which corresponds to the net cluster octupole polarization of each PtMn3 layer.
Western Digital fabricated the devices, with pillars as small as 50 nm, by sputtering the films onto 150 mm silicon wafers at room temperature, with no post-deposition annealing. The best device reached a tunneling magnetoresistance (TMR) of 363% at room temperature, and switching current densities were in the order of 10 MA/cm2.
Antiferromagnetic MRAM could, in principle, enable much higher densities and terahertz-range switching speeds compared to today's ferromagnetic MRAM, as antiferromagnets produce no stray fields and are robust against external magnetic fields. This is still early-stage research, though. Most measurements used 1-millisecond write pulses (the picosecond-scale switching was only simulated), limited endurance restricted the number of measurements per device, and 32 of the 50 devices tested had a TMR below 100%. Switching and readout also disappeared at around 87-127 °C, returning after the devices cooled down. Next steps include testing other antiferromagnetic materials, directly probing the terahertz dynamics and integrating the junctions with semiconductor electronics.
In 2024, the same Northwestern group reported the first all-antiferromagnetic tunnel junctions with both electrical switching and electrical readout. The research was published in Nature.